What are the Diag Tape Changer commands, and how are they used?
NOTE: Before reading this article, Mirapoint highly recommends reading the latest version of the Mirapoint Backup and Restore Guide.
If the output of the Inquiry command says the device is unsupported, that device is not certified for use with a Mirapoint appliance.
If the output of the Inquiry command says the firmware is untested, that means the firmware has not been tested, we do certify the device for use with a Mirapoint appliance, but we have not encountered this revision of firmware and that your results may vary.
As of Release 3.4, the Get *Address command now publishes the device name, which is used when configuring your NDMP client.
For more information on these commands, see the online CLI help, or the Mirapoint Administration Protocol Reference for your MOS version.