Posted by Gary Garber, Last modified by Marek Puverle on 14 May 2015 07:45 AM
Limits in IceWarp
Here you can set maximum message size, which has highest priority in compare to other message limits. This limit is global, so if some user is allowed to send bigger message, this is more important so the message will not be accepted by mail server.
Maximum number of simultaneous connections. This can help you in optimizing server load and also helps you find, that something is disordered (when normally max connections are 50 and after 750, something is wrong). Set number a little bit bigger than average load (can be found in statistics or services).
You can set disk quota in kB, MB or GB which is applied to selected domain. After this quota will exceed, all messages will be rejected by error 5.2.2. You can easily check used data of each domain in Status --> Domain section.
If your provider controls amount of data you are sending or you have to block big amount of outgoing data, use this limitation to help you.
Domains & Accounts > Management > name_of_domain > Limits tab
To makes your server more secure, it's better to use this limitation. Imagine situation, that some of your accounts have been stolen by spammers. If this limitation will be set to whole domain (be careful, set bigger number than usually you are sending) you can avoid this annoying situation. This limitation can be also set on user's level, which is may be easily to set, due to ability to guess amount of messages.
You can set maximum size of each user's mailbox to any number. There are two ways hot to do that. You can set that "globally" in :
Domains & Accounts > Management > name_of_domain > Limits tab or you can set that individually for each user. As in global limits were mentioned, global limitation has highest priority, so if user firstname.lastname@example.org has it's own limitation ofINBOX set to 300MB but domain limitation is set to 250MB, he will be able to dispose only 250MB.
Here you can define size of each message which will be maximum a day for that user to sent.
As in domain level has been mentioned, here it's in user's level. You can define amount of data which can be sent by concrete user a day.
Again, as in domain level, you can define for each user number of messages which can't be overreached. It's very useful to avoid some intrusion in the server by spammers.
Updated 27.06.2014, by Valentin